Flex 4Base® CE Instruction Manual
January 2017
Page 22 of 41
7
1
4
2 3
5 6
8
4.1.8.4 A/B Pushbutton Select with LED Indication – Inline Top/Bottom
Pushbutton Configuration
There are four different types of A/B selector sequences available. Choose one that is most
suitable for your application. Refer to Section 4.2.4: Jumper Settings
Error! Reference
source not found.
and Section 6.1: Output Relay Contact Diagrams.
Type-A selector sequence: A
→
B
Type-B selector sequence: Off
→
A
→
B
Type-C selector sequence: A
→
B
→
A+B
Type-D selector sequence: Off
→
A
→
B
→
A+B
Function
Number
Display
Type
PB1 PB2 PB3 PB4
49
4 9 Reds
Normal
Normal
A/1&2 Normal
50
5 Greens
Normal
Normal
B/1&2 Normal
51
5 1 Reds
Normal
Normal
C/1&2 Normal
52
5 2 Reds
Normal
Normal
D/1&2 Normal
29
2 9 Reds
Normal Normal Normal A/1&2
30
3 Greens
Normal Normal Normal B/1&2
31
3 1 Reds
Normal Normal Normal C/1&2
32
3 2 Reds
Normal Normal Normal D/1&2
* PB1…PB4
→
Pushbutton number.
* Normal
→
Normal momentary contact.
* A/1&2 ~ D/1&2
→
A/B pushbutton select function with designated LED indication.
4.2 Receiver
4.2.1 Receiver Channel Settings
Set the receiver channel by configuring the channel dipswitch
located on the RF/decoder board; only the first six dip positions are
used for channel programming. The system channels table on
Section 5 illustrates which dipswitch setting corresponds to which
channel. Once the receiver channel is altered make sure to change
the transmitter channel as well. The channel on both the transmitter
and receiver must be identical in order for the system to work (refer
to Section 4.1.2: Transmitter Channel Settings).
Example:
Top position
→
“1”
Bottom position
→
“0”
NOTE: The above dipswitch setting
“1 0 0 1 0 0”
corresponds to “channel 36” in the system
channels table on Section 5.
