Installation
6
Mechanical Mounting Instructions
The following parts need to be mounted on to the motor: proximity sensor (red device with 3 wires
coming out of it as shown in
), incremental encoder, rider wheel, sensor bracket, target, sticky
pad, and hex nuts.
Figure 2: Axial Flux Assembly Kit
Figure 3: Picture of Proximity Sensor (PN
05P00217-0097)
1. The rider wheel should be tightly fitted on
the incremental encoder’s shaft as shown
in
Philips head screw driver depending on
the wheel type). It should be positioned so
that the wheel will sit on the center of the
exposed edge of the rotor.
NOTE:
if the
encoder shaft has a keying slot, do NOT
place any of the set screws in the keying
slots.
Figure 4: Incremental Encoder with the rider
wheel
fitted on shaft
encoder
rider wheel
