Magicard Rio Pro, Руководство по обслуживанию

Страница: 46 / 108

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 46 -
Removal & Refitting of Card Thickness Adjuster
1. Remove the cleaning roller and the rubber cleaning / feed roller below it.
2.
Remove the return spring from the plastic locating pin from the back of the Printer.
3.
The complete plastic Assembly will be loose, unclip from the plastic Side Plates and
withdraw from the Printer.
Refitting is the reverse procedure. Locate the assembly into position and refit the return
spring into position.
SECTION 11.4 REMOVAL AND REFITTING OF THE CARD THICKNESS ADJUSTER
SECTION 11.5 REMOVING & REFITTING THE CONTROLLER PCB.
CAUTION The following procedures involve contact with Electrostatic Sensitive Devices. All precautions for
handling Electrostatic Sensitive Devices should be followed at all times, including the use of a grounded
wrist strap.
Removal & Refitting the Controller PCB
1. Disconnect all the wiring from around the outside edge
of the Controller PCB.
Take care not to damage the small PCB connctors.
2.
Unclip the four plastic catches and remove the
Controller PCB downwards.
3.
On Rio Pro and Rio Pro Duo Printers with the Magnetic
Encoding and OmniKey options an extra PCB will need
to be disconnected, it is mounted onto the main
Controller PCB.
4.
The plastic moulding around the USB and power
connector will also fall away.
Refitting is the reverse procedure ensuring the plastic
molding is around the USB and power connector is included.
Spring fits between
moulded plastic
parts.