Magicard Rio Pro, Руководство по обслуживанию

Страница: 16 / 108

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 16 -
CR80
85.6mm or 3.375”
CR79
83.9mm or 3.303”
CR80
53.98mm or 2.125”
CR79
51mm or 2.051”
CR80
– 1016 Pixels
CR79
– 990 Pixels
CR80
– 642 Pixels
CR79
– 601 Pixels
Recommended
page size for
edge to edge
printing
ISO Standard Cards
Sizes
Printable Area of Cards
SECTION 4.2 CARDS
Card Material
Not all white plastic Cards are the same. For best image quality always use high quality grade PVC Cards.
Pure PVC Card stock or laminated PVC/Polyester Cards are available. The latter are more durable and better suited to
heavy use and heat lamination when required. For access control and smart Card applications, your Dealer should
provide the appropriate type for
“direct to Card” printing. For good consistent results, stick to a single variety of good
quality Cards, such as those available from your Magicard Dealer.
Card Size
Card Thickness
Minimum 0.51mm
0.020”
Standard 0.76mm
0.030”
Maximum 1.02mm
0.040”
To obtain good quality prints the Cards must be:
Glossy white.
Free from dirt or grease.
Free from surface contamination (e.g. finger marks).
Free from burrs at the edge of the Card.
Free from pits or bumps in the surface.
Printable Area of the Card.
Both the Rio Pro and Rio Pro Duo Printer offer high quality edge to edge (Full Bleed) printing. Thus the surface of the
Card may be printed edge to edge.
Die cut PVC Cards typically have an edge roll off (bevel) which can result in a thin white line around the edge of full bleed
printed Cards. When setting up your Card design using your graphics software on your PC, you should use a maximum
page size of 1016 pixels (3.375”/85.6mm) x 642 pixels (2.125”/53.98mm).