30 / 33
If the phase is not identified, no other LEDs light up
Repeat steps for other phases to identify
Move the EE2 to the next electrical cabinet and start again at step 1:
calibration, then measurements upstream and downstream of the cable
segment.
3.2.3.Batteries
The Receiver is powered by two 9 Volt batteries.
When the battery charge level is insufficient for correct operation of the
Receiver, a LED indicates the fault.
To Change the Batteries: Unscrew the battery compartment on the
bottom of the receiver and replace the 2 batteries with similar ones.
Be careful to the direction
Warning: replace the batteries with equivalent models, of the
6LR61, 9V alkaline type.
Do not replace batteries with Lithium types
