22 / 33
If the answer is YES, it is always good to confirm this by
repeating the measurement at several points along the
cable.
The receiver indicates by « YES » the identification of the cable.
3.2.1.2.Core identification in open circuit and continuity
to S1 Transmitter mode
JPRX_CAP_220
A voltage absence check is required before using this mode
Connect the red probes to the receiver, press the « Start »
button, the “
Open circuit identification
” LED illuminate.
Don't forget to test the fuse
Before each use, touch the 2 test probes and press the «
Fuse control » button.
If the fuse is good, the YES and END of measurements
LED illuminates.
If the fuse is blown, the YES LED remains off and the
END of measurements LED illuminates
In this case replace the fuse.
Unscrew the test probes and replace the fuse with an
identical one (2A 500VAC / HPC 50KA)
Mode usable in all cases.
