25 / 33
Mode usable in all cases
The sensor intended for this function has two flexible loops, of which
one serves as a reference and the other for the measurement
(marked
red
).
• Connect the short circuit for 4 drivers to the end of the cable
• Connect the double loop to the Receiver; a press of the «
measurements » button lights the LED which indicates the mode
• Put the loop marked
red
around the core to identify, and close it
• Put the unmarked loop around any other core and close it. This
core serves as a reference during the identification of the other
cores. This reference core will then be identified by the
red
loop
using one of the previously identified cores as reference
• Press the « measurements » button
• Wait for the result (3 seconds), either L1, L2 or L3 or NEUTRAL
(
blue
LED on the connector),
THE IDENTIFIED CORE IS THE
ONE PASSING THROUGH THE LOOP MARKED
RED
• Repeat the operation to identify the other two cores
• Switch the loops after the last core has been identified, to be able to
identify the core which has served as reference.
•
•
The receiver designates the core within the measurement loop
marked with red
.
