10 R2 Series Clinic Handout
Settings
1 . Loosen jam nut
(A)
on both sides of the conditioner . Turn lower
bolt
(B)
counterclockwise until the upper roll rests on the lower roll .
Ensure the rolls inter-mesh .
2 . Turn lower nut
(B)
two and a half turns counterclockwise to raise
the upper roll and achieve a 6 mm (1/4 in) roll gap .
3 . Hold nut
(B)
and tighten jam nut
(A)
on both sides of the conditioner .
4 . If further adjustment to roll gap is required:
Turn lower nut
(B)
clockwise to increase roll gap .
Turn lower nut
(B)
counterclockwise to decrease roll gap .
Set forming shield side deflectors
(A)
to the desired width by repositioning
adjuster handle
(B)
. To ensure windrow placement is centered, adjust both
side deflectors to the same position .
Conditioner Roll Gap
Forming Shields
Important:
Make sure the roll gap adjustment nuts are adjusted equally on both sides of the disc header to achieve a consistent gap
across the rolls .
Содержание R2 Series
Страница 1: ...R2 Series Clinic Handout...
Страница 20: ...MD 1000C2 R2 Series Clinic Handout 4 5 2020...
