R2 Series Clinic Handout 13
1 . Use the Header Tilt switches
(A)
on the ground speed lever (GSL)
to set the center-link to the mid-position (5 .0 on the monitor)
2 . Using the header down button
(B)
, lower the header fully and ensure
the header lift cylinders are fully retracted .
3 . Grasp one end of the header and lift . The force required to lift the
header should be 426 – 471 N (95 – 105 lbf) .
The force required to lift the header should be equal on either side .
If adjustments to float are required
4 . Press rotary scroll knob
(A)
on the HPT (monitor) to display the
QuickMenu system .
5 . Rotate scroll knob
(A)
to highlight header float icon
(B)
and press
scroll knob to select .
6 . Turn scroll knob
(A)
to highlight left
(B)
or right
(C)
float and press
knob
(A)
to activate selection .
7 . Rotate scroll knob
(A)
to adjust float setting and press knob when
finished . Float is now set .
8 . Use softkey 3
(D)
to remove/resume float to previous setting when
attaching or detaching the header .
Setting Header Float
Note:
Float adjustments of 1 .0 (out of 10) change the header weight at the cutterbar by approximately 91 kg (200 lb .) .
Adjust float in increments of 0 .05 to optimize field performance .
Too heavy float causes skid shoe wear, too light float causes excessive header bouncing over uneven terrain .
Содержание R2 Series
Страница 1: ...R2 Series Clinic Handout...
Страница 20: ...MD 1000C2 R2 Series Clinic Handout 4 5 2020...
