![background image](http://html.mh-extra.com/html/macdon/m155/m155_operators-manual_685734144.webp)
OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.155: M155 CDM Programming Buttons
4. Press SELECT (B) until VIEW CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
HEADER TILT is displayed on the upper line.
• The control switch status is displayed on the lower
line. The hours displayed indicate when a switch
was enabled or locked.
Figure 3.156: M155 Control Locks
147649
128
Revision A
Содержание M155
