MacDon M155, Инструкции по разгрузке и сборке

Страница: 165 / 272

215015
139
Revision A
1009330
CXXX
MXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 4.113: Functions
5. Press SELECT (B) until ACTIVATE FUNCTIONS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
CAUTION
Check to be sure all bystanders have cleared the area.
1009289
CXXX
MXXX
ACTIVATE HEADER HT
DOWN/UP
D
C
B
A
Figure 4.114: Header Height
7. Press SELECT (D) until ACTIVATE HEADER HT is displayed on
the upper line.
•
DOWN/UP is displayed on the lower line.
8. Press and hold left arrow (B) to lower header, or press and
hold right arrow (C) to raise header. Verify header is
functioning properly.
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next ACTIVATE FUNCTION.
4.9.2 Testing the Reel Up/Down Activate Function Using the Cab Display Module
NOTE:
•
This procedure is for draper headers only.
•
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.115: CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode. Press SELECT (B).
•
WINDROWER SETUP? is displayed on the upper line.
CAB DISPLAY MODULE