MacDon M155, Инструкции по разгрузке и сборке

Страница: 159 / 272

215015
133
Revision A
1010020
CXXX
MXXX
VIEW ENGINE CODES?
NO/YES
C
C
B
A
D
Figure 4.100: Engine Codes
10. Press right arrow (C) to select YES. Press SELECT (D).
11. Press left (B) or right (C) arrow to cycle through the last ten
recorded engine error codes until EXIT ENGINE CODES is
displayed.
12. Press right arrow (C) to select YES. Press SELECT (D).
13. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next diagnostic mode.
4.8.2 Switching the Installed Header Sensors ON or OFF
You can selectively enable or disable header sensors in the event of a malfunction or as part of a troubleshooting routine.
NOTE:
•
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
Disabled sensors flash the word SENSOR on the CDM during regular operation.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.101: CDM Programming Buttons
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3. Press SELECT (C) until DIAGNOSTIC MODE? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
4. Press right arrow (B) to select YES. Press SELECT (C).
•
VIEW ERROR CODES? is displayed on the upper line.
CAB DISPLAY MODULE