PRE-DELIVERY INSPECTION
169603
33
Revision
B
I. REEL TINE TO CUTTERBAR
CLEARANCE
The finger to guard/cutterbar clearances with reel
fully lowered varies with header width, and are as
follows. See illustration opposite.
HEADER
‘X’ +/- .12 in. (3 mm) @ REEL ENDS
SINGLE REEL
DOUBLE REEL
15 FT
.78 in. (20mm)
---
20 FT
25 FT
1.00 in. (25 mm)
30 FT
1.77 in. (45 mm)
0.78 in. (20 mm)
35 FT
2.36 in. (60 mm)
40 FT
---
45 FT
CAUTION
Engage header lift cylinder stops before
working under header.
a. Raise header, and place a 6 in. (150 mm) block
under each inboard header leg.
b. Lower header onto blocks, and fully lower
the reel.
c. Adjust fore-aft reel position so that back end of
cam disc is approximately between 4 and 5 on
the arm decal.
(continued next page)
X
Z
Y
TAKE MEASUREMENTS 2 PLACES
SINGLE REEL
6 INCH BLOCKS LEVEL GROUND
6 INCH BLOCKS
LEVEL GROUND
TAKE MEASUREMENTS 4 PLACES
DOUBLE REEL