Maber MB500/120-SP, Инструкция по эксплуатации и техническому обслуживанию

Страница: 26 / 52

26
20. START-UP
To start up the machine:
x
Enable the main power knob on the control panel,
x
Grip the control board,
x
Press the start button,
x
Press the up button to raise the deck a few metres,
x
Release the control and check the machine stops regularly (must stop instantly),
x
Press the down button and return to the bottom terminal switch.
Repeat the above steps making sure that:
x
Movements are regular,
x
The deck stops regularly when the up and/or down button is released,
x
The power supply cable unwinds and rewinds regularly from its container.
Load the deck making sure that:
x
The required loads are compatible with the machine operating guidelines, as described
in paragraph “3”.
x
The load is evenly distributed on the deck,
x
The load is stable and tied, if necessary, secured with ropes or fasteners.
x
After loading the access ramps and the guard upper protecting bars have been regularly
closed.
!!! CAUTION!!!
In a case of emergency requiring the machine to be immediately stopped, press the
red STOP button on the control board or switch off (“0”) the switch located on the
main control panel.
x
Enable ascent until the required storey has been reached,
x
The exact stop at a storey is ensured by the preset moving stop switch runner: See
page 24.
x
When the required height has been reached the operator on the storey may open the
barrier, release the stop lock of the turning plate and turn the deck.
x
Lift the protecting bar and lower the access ramp.
x
Unload goods.
x
Refit the ramp, lower the bar again and turn the deck to the regular position again.
x
Close the barriers again.
21. SETTING THE MACHINE UP FOR IDLING
In all cases in which the machine may not be used (see application), at the end of the
operating hours and in any case during idle periods when the frame is assembled, the lift
must always be set up for idling by following the procedures described in this section:
x
Lower the deck down to ground level,
x
Disable the main power knob on the control panel (turning it to “0”),
x
Unplug the control board from the power supply cable and keep it in a safe place
inaccessible to other people,
x
Remove the power supply cable,
x
Take all possible measures to prevent unauthorised persons from using and gaining
access to the lift.
COPY