Maber MB500/120-SP, Инструкция по эксплуатации и техническому обслуживанию

Страница: 20 / 52

20
If you are in the assembly stage, take the following steps:
CAUTION: Load at most 3 vertical column modules on the deck.
The operators on the deck must always work with their safety belt fastened to the
deck to ensure they are suspended if they slip off.
x
Raise the deck up to the top limit of the pre-assembled column, lower the guard (1) and
couple the new module, making sure with
utmost care that the screws are tightened.
x
To reactivate ascent, always refit the guard
(1) .
x
Then proceed likewise for the remaining
modules up to the desired height.
!!! CAUTION!!!
2 m. above the ground the temporary
assembly and disassembly wall bolt must
be attached by clamping it with wall plugs
or other tools as shown in the diagram on
page 22. The wall or the support scaffold
must be able to bear the transmitted loads.
Then attach the wall mounting at least
every 6 m.
x
If necessary attach stroke limit stop runners
on the storey (3) so as to ensure it stops at
a preset height.
x
Make sure that the storey accesses are
adequately cordoned off and fitted with
warnings on special signs attached to the
inside of the building well stating “free fall
hazard”.
x
Every 9 m. (every 6 m in windy areas)
attach cable-guides (4) onto the vertical
column.
After assembling the last vertical column, fit the
up terminal switch runner. Also install the
last wall mounting even if the distance
from the previous one is less than 6m.
x
After assembling the vertical column lower
the deck to ground level.
x
Remove the control board coupled directly
on the control panel.
x
Couple the control board onto the
connector to operate from the ground.
COPY