WARNING
Wall Station
5 Foot
Minimum
Lower Screw Installation
Upper Screw Installation
7/16”
Keyhol e
Slot
Phillip s
Head Screw
Phillip s
Head Screw
Phillips Head
Screw
Tools Required – Power Drill, Phillips Head Screwdriver, 3/32 inch drill bit, 3/16 inch drill bit.
TO PREVENT POSSIBLE INJURY, INSTALL WALL
STATION OUT OF THE REACH OF CHILDREN AND
IN A LOCATION WHERE THE DOOR CAN BE SEEN
WHEN THE OPENER IS ACTIVATED.
DO NOT MOUNT WALL STATION NEAR OR NEXT
TO GARAGE DOOR.
NOTE:
For proper operation, mount the wall
The wall station can be mounted to a NEMA
standard electrical box or directly to any wall
surface. No wiring is required.
Locate wall station adjacent to service entrance
door at a minimum height of 5 ft., and at least 6 ft.
away from garage door.
Install lower screw leaving 7/16" of the screw
exposed. Slide wall station keyhole slot onto
the lower phillips head screw.
Wall station should slide onto screw, providing
loosen or tighten lower phillips head screw until
Do not over-tighten.
9
Deluxe Multi-Function Wireless Wall Station Installation
(If Included)
If mounting to a NEMA electrical box, use machine
thread screws (provided) in place of the wood screws.
No drilling is required. If high voltage wiring is
contained in the box, a standard NEMA solid faceplate
must be installed between the box and the wall station.
If fastening into drywall or concrete, use anchors provided.
When mounting to wood use a 3/32" drill bit and the
drilling template located at the end of the manual. Drill
the two 3/32” mounting holes using the drill template.
Drill 3/16" holes if using anchors.
CAUTION:
Over tightening the upper screw could deform plastic case.
15
