Maintenance
Programing for HomeLink® to the Operator
NOTE:
This step can only be done on automobiles equipped with the HomeLink® System.
NOTE:
Programming HomeLink® requires a Transmitter that is programmed to the opener (the wallstation and
transmitter(s) supplied with the opener, come pre-programmed from the factory). Any additional wallstation(s) or
transmitter(s) will need to be programmed to the opener.
IMPORTANT:
Use the programming instructions provided with your vehicle first. Follow these instructions if the
HomeLink® unit does not learn the transmitter, when using the vehicle’s instructions.
NOTE:
If Primary Programming does not work then use the Alternate Procedure on next page.
NOTE:
Vehicle may need to be in accessory position when programming. Check car owner’s manual.
NOTE:
HomeLink® is a registered trademark of Johnson Controls.
Programming/Training HomeLink® Unit
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID POSSIBLE SEVERE OR
FATAL INJURY, PLACE THE EMERGENCY DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1.
With the door in the fully closed position, pull the manual disconnect to put the opener in the disengaged position.
2.
Verify the HomeLink® unit has an empty channel. Press the desired HomeLink® button and observe the indicator
light if it flashes slowly, the channel is empty and ready for programming. If pressing the desired channel/button
causes the indicator light to blink rapidly, or come on without blinking this channel is already programmed. You
either need to choose a different channel/button on the HomeLink®, or perform Step 3 below.
3. OPTIONAL
– To completely clear all channels on the HomeLink® unit, press and hold the two outside buttons on
the HomeLink® unit until the HomeLink® indicator light begins to flash rapidly (approx. 20 seconds), then release
both buttons. (Do not perform this step to train additional hand-held transmitters.)
NOTE:
This operation erases all previously learned transmitters and you will need to re-teach any other
transmitters to your HomeLink® unit.
4.
Hold the end of the hand-held transmitter approximately 1 to 3 inches away from the HomeLink® surface keeping
the HomeLink® indicator light in view.
5.
Simultaneously press and hold the transmitter large button and desired button on the HomeLink® module,
continue to hold both buttons. In less than 10 seconds the LED on the HomeLink® module will either go solid or
give a single quick flash (or, in some cars, will change from blinking slow to blibking fast). Release both buttons.
NOTE:
If this procedure is unsuccessful perform Alternate procedure.
Teaching HomeLink® to the opener
6.
Press and hold the LEARN button on the opener . The Right LED on the opener will turn on and remain on for
one minute, indicating that it is ready to learn.
7.
Press the HomeLink® button used in Step 5 above for 1 to 3 seconds. The Right LED on the opener and the lights of
the opener will turn on and off three times indicating a successful learn.
8.
Press the HomeLink® button once more to operate the door. The opener will activate and the trolley will travel
towards open, the next activation will cause the trolley to travel to the closed position and reengage, subsequent
operations will move the door.
WARNING
31
