Program Button
Up/Down Button
Customizing the Settings
Custom pet position:
The pet button opens a closed door to a preset position between 5 and 30 inches
above the floor, allowing pets to enter and exit the garage without the door being
fully open. To change the automatic pet opening height:
Start with the door in the closed position.
1.
Open the door then stop it (by pushing the Up/Down button
while the door is moving up) at the desired height. If desired
height is not achieved, the door must be returned to the closed
position.
2.
Press and hold the Wall Station Program button until the LED lights on
the Wall Station blinks fast. Release the Program button. The overhead opener
lights will flash on and off at a slow rate.
3.
Press the pet button while the overhead lights flashing (within 10 seconds). The LED lights on the Wall
Station blinks fast for a short time, the overhead opener lights will flash on and off two times indicating
successful programming or four times (fast) if you trying to set it up outside the door limits.
Backlit LED Light:
The red LED blinks intermittently to help you locate the wall station in a dark garage. This blink rate can be
changed for longer battery life or can be turned off. The default blink rate is one blink every 3 seconds.
For longer battery life the blink rate can be changed to blink once every 6 seconds.
To change the blink rate, remove the battery cover and remove one battery.
Re-install the battery and within 2 seconds, press the Light button.
Re-install the battery cover.
For longest battery life, the blink can be turned off. To turn off the blink, remove the battery cover and remove
one battery. Re-install the battery and within 2 seconds, press the Pet button.
Reinstall the battery cover.
Multi-Door Programming:
Momentarily pressing the button programmed in the transmitter programming
step activates the door. Other buttons can also be programmed to activate
different doors, for multi-door installations. Each button or a combination of two
buttons pressed simultaneously can be programmed to activate a different door.
Only one button at a time can be programmed to activate a specific opener.
Opener Controls
The LEARN button located on the back side of the opener (under a door) has several functions.
1.
Pressing and holding the LEARN button for about 3 seconds, will turn on the Right LED. This mode allows
programming of transmitters, wireless keyless entry, and wireless wall stations. The programming mode is
exited if no activity is performed within 15 seconds.
2.
Pressing and holding the LEARN button for 10 seconds will erase all transmitters, multi-function wall
station and wireless keyless entry from memory. The Right LED will blink 8 times indicating a successful
erase operation.
30
