22
Installing Wireless Keyless Entry (If Included)
Tools Needed: Power Drill, 5/64” Drill Bit, Phillips Head Screwdriver
IMPORTANT:
INSTALL ALL WALL CONTROLS OUT
OF THE REACH OF CHILDREN AND IN A LOCATION
WHERE THE DOOR CAN BE SEEN BEFORE ACTIVATING.
Locate a convenient place to mount the wireless
keyless entry, that does not interfere with the
normal opening and closing of the door. To keep
keyless entry out of the reach of children, measure
and mark a spot at least 5 feet up from the floor.
Use the drilling template included in this manual
to determine hole positions. Drill 5/64” pilot holes
3/4” deep at each screw location.
Snap open the wireless keyless entry case with a
coin. Secure keyless entry base into wood framing
using the two screws provided. Snap the front case
half back onto the base. Remove paper backing
from instruction label and apply to a clean
surface inside garage.
NOTE:
Two screws are included for
mounting to wood structures. Ensure proper
hardware is used for mounting to other
materials.
5’
Keyless Entry
Screws
Keyless Entry Base
Keyless Entry Front
Case
26
