Lutron Electronics EcoSystem, Техническое руководство

Страница: 27 / 32

In order to ensure that environment sensors and personal controls
do not override each other in a way that disturbs users, a hierarchy
was established for the sensor and control inputs.
Input Priority to EcoSystem Ballast or BMF (highest to lowest)
Priority 1: Emergency Command (typically lights to full on)
Priority 2: Configuration Commands, Status Responses, Addressing Commands,
and Load Shedding (ballast responds to in-progress programming)
Priority 3: Occupancy Sensor Input
Priority 4: Daylight Sensor Input
Priority 5: Personal Control (IR, wallstation), IR Input, Phase Control
The occupancy sensor turns the lights on to
the programmed “occupied” level.
If enough daylight is entering the space, the day-
light sensor will reduce the light level to maintain
the designed proper luminance level for the room.
In the middle of the day, the light level is reduced
to the load shed level to reduce energy during
peak usage hours.
If the person uses a wallstation or IR remote they can
adjust the light level below the level set by the daylight
sensor. The person always has the flexibility to set
the lights to any level below the maximum light level
programmed for the room.
After a programmed time-out setting, the occupancy
sensor will set all the lights to the programmed
“unoccupied” level.
A
A
D
F
E
B
C
B
C
D
E
F
Light Levels
8am 9am 10am 11am 12pm 1pm 2pm 3pm 4pm 5pm 6pm
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
26
|
Lutron
www.lutron.com/ecosystem Lutron World Headquarters: 1.610.282.3800
EcoSystem
™
|
system hierarchy