3. THE NEW RDM EXPERIENCE
Not only can the LumiSplit provide you with some great features
directly from its front panel, the unit can also be remotely
configured and monitored, all through RDM connectivity.
Once LumiNet Monitor is connected to a Luminex LumiNode
or Ethernet-DMX converter with RDM enabled, the software will
provide you with a comprehensive set of tools to monitor and
configure your LumiSplit 2.10.
The LumiSplit 2.10 can be monitored and configured through
LumiNet Monitor.
Luminex recommends the use of a Luminex converter and
LumiNet Monitor to enter a new RDM experience.
LumiNet Monitor 2.1.6 or higher and LumiSplit firmware v5 or
higher are necessary to take full benefit of all the features listed
below.
3.1 Discovery
Wrong text. Should be: The LumiSplit 2.10 comes with two RDM
responders (A & B). In the RDM panel, two responders will appear
per splitter, if both are connected to the RDM controller.
If you hover your mouse over the responder, additional information
will be available.
3.2 Identify a LumiSplit
If you have many LumiSplit devices, it can come in handy to identi-
fy a unit. Right click on one of the responders and select Identify ->
On. All LEDs will turn white and start flashing, to identify the unit.
To stop the identification, repeat the same procedure and select
“Off”, or click on the “Identify OFF” button on the top right-hand
side of the RDM panel.
9
