Chapter 3
_________________________________________________________________________________________
_____________________________________________________________________________
BE6020-14
1316A-1 Multi Gas Monitor
LumaSense Technologies A/S
Instruction Manual
Page 47 of 98
Figure 3.10. The BZ 6012’s status Screen
The BZ 6012 and 1316A-1 have built-in test procedures that are able
to monitor various electronic and mechanical parts – for example,
the flow rate. If anything abnormal is detected with any of the
parameters tested for, the error will be reported in the status screen
see figure 3.10.
The status screen in figure 3.10 shows that zero calibration is
required.
The System status and Data Status messages are described in this
manual when relevant for the task performed in a given section.
The problem status messages are described in section 3.4 below.
3.4
Screen Problem Status
In the bottom part of the Status screen, see figure 3.10, error and
warnings are displayed. If a fault status is discovered the text box text is
changed from
OK
to
Check
.
