Lumag RP-110HP, Инструкция по эксплуатации

Страница: 24 / 32

4
TROUBLE SHOOTING
9. TROUBLE SHOOTING
Trouble Reason Measure
The working speed too low,
the plate doesn´t reach highest
speed
Gas lever assembled in the
wrong way
Adjust assembly!
Surface too wet. Compactor gets
stuck.
Foundation has to dry up
Belt not tight enough, skids.
Adjust belt tension or replace
it. Check motor bolts for proper
pulling
Air filters dirty Clean or replace
No compacting effect
Damages on the agitator or on
the plate
To be checked by authorized
workshop
Motor drains oil
Worn-out washers or O-ring
washers
To be checked by authorized
workshop
The plate operates in an uneven
way, or is beating
Surface to hard
Surface can´t become more
compressed
The shock absorber loose or
worn-out
To be checked by authorized
workshop
Motor doesn´t start
No gas in the tank Refill
Fuel tap closed Open the tap
Air filters contaminated Clean the filters
Power switch in position OFF Put in ON position
Starting unit faulty Let repair!
No oil Refill
If suggested measures should not solve the problem, or should problems occur which are not
stated in this list, refer the problem to authorized workshop.
RP-110HP_manual_GB.indd 24 04.02.2010 09:23:05