Lumag RP-110HP, Инструкция по эксплуатации

Страница: 16 / 32

16
7. TAKING INTO OPERATION
WARNING
Carefully read the safety instructions for this section.
7.1 Type of fuel
For this motor only standard type of non-leaded petrol octane-91 shall be used. Only use new
and clean petrol. Water and contaminations will damage the fuel system.
(Fig. 3)
Volume of fuel tank: 3, 6 liter
Refuel only in well ventilated surroundings and with the motor turned off. If the motor has been
in operation prior to this, let it first cool down. Never refuel I surroundings where the fuel gases
can caught on fire by sparks or open fire.
Petrol is a very inflammable and explosive liquid. The handling of fuel can cause burns
and other serious injuries.
• Stop the motor and keep it away from heat, sparks and open fire.
• Only refuel outdoors.
• Immediately remove spilled out fuel
7.2 Before taking into operation
Before starting the motor the first time, motor oil has to be filled. If not, the motor will become
seriously damaged which cannot be repaired. All warranties are consequently void.
(Fig. 4 + 14)
Use normal motor oil, 10W-30 or 10W-40
Remove the screw for oil refill (13)
Fill up oil till the level is visible at the windings (= lower part of the refill hole). Volume: ca. 0, 6
liter (don´t overfill!)
Before start, check:
Oil level
Fuel level (at least half the tank)
Air filter
Fuel pipes
Outside bolt and nut joints are firmly tightened.
•
•
•
•
•
•
•
•
WARNING WARNING
NOTICE NOTICE
TAKING INTO OPERATION
RP-110HP_manual_GB.indd 16 04.02.2010 09:23:02