Lumag RP-110HP, Инструкция по эксплуатации

Страница: 23 / 32

3
MAINTENANCE
• Put back the oil refill screw and pull tight.
• Put back the belt (check the tension!)
• Put back console and motor assembly.
Replacement of oil in the agitator:
To be replaced every 300 hour.
• Remove the drain screw (22) with washer.
• Tilt the plate and let oil out in suitable container.
WARNING
To protect the environment, put a sheet of plastic film and a container
under the equipment to collect the oil. At disposal of the old oil, respect
the environmental regulations. Oil may never be disposed of in moldering
beds or any other water streams, sewage or earth deposits.
• Put the plate back in horizontal.
• Refill transmission oil SAE 80W-90 (ca. 350 ml.) until the oil is in level with the windings in the
refill hole. (use funnel)
• Put back the refueling screw and washer.
DO not overfill. Too much oil in the agitator will reduce the power and damage the belt.
8.9 Cleaning the plate
After every period of operation, dirt and stones which got stuck under the motor console must be
removed. To prevent overheating of the motor, the cooling flanges on the cylinder must be kept
clean.
OIL OIL
NOTICE NOTICE
GB
RP-110HP_manual_GB.indd 23 04.02.2010 09:23:05