LTH Electronics HPT63, Руководство по эксплуатации

Страница: 61 / 68

21 Appendix F – Error Messages
53
21 Appendix F – Error Messages
Switch On Diagnostic Errors
E01 Processor RAM Read/Write Error
Try switching the unit off then on again. If the message persists,
consult with your supplier, as this unit will require to be returned for
repair.
E02 Reserved for future use
E03 PSD RAM Read/Write Error
Try switching the unit off then on again. If the message persists,
consult with your supplier, as this unit will require to be returned for
repair.
E04 Setup Checksum Error
The instrument configuration has for some reason become corrupted.
Restore a setup from store A or B, or one of the two default setups.
E05 Store A Checksum Error
The data in setup store A has been corrupted. Save the current setup
back to store A.
E06 Store B Checksum Error
The data in setup store B has been corrupted. Save the current setup
back to store B.
E07 Factory Calibration Checksum Error
The factory calibration data for this instrument has been corrupted.
The
instrument will need to be re-calibrated. Consult your supplier.
E08 User Calibration Checksum Error
The user calibration data has been corrupted. Reset the user
calibration and re-enter
Calibration/Sensor Errors
E11 1V Cal Err
F1.0V calibration value is out of specification. Sensor requires
recalibration. Contact LTH or agent.
E12 -1V Cal Err
Factory -1.0V calibration value is out of specification. Sensor requires
recalibration. Contact LTH or agent.