LSIS XBL-EIPT, Руководство пользователя, Страница: 33 / 123

Chapter 3 Installation and Trial-Run
3-8
3.6 Trial- Run
3.6.1 Directions when Configuring Systems
1)
To use P2P service including this module, make sure IP Addresses of all stations are different from IP addresses of
all other stations.
2)
To use communication cables, select the ones in designated sizes. Using cables that have not been designated
may cause serious communication obstacles.
3)
Check out whether cables are disconnected or short-circuited before installing communication cables.
4)
Completely tighten the connectors of communication cables so that cable connections can be fixed.
5)
Incomplete cable connections may cause serious obstacles to communication.
6)
In case of connecting communication cables to a long distance, make sure cables are not separated from power
lines or inductive noises.
7)
Coaxial cables are low in flexibility, so they must be re-branched lowering down at least more than 30 cm from the
connector in communication module, and if cables are bent on the square and forcibly transformed, it may cause the
destruction of the connector located in the communication module.
8)
In case LED does not normally operate, refer to ‘Chapter 10 Troubleshooting’ and check out causes. If something
is wrong even if actions have been taken, contact Warranty Service Center.