3 - 54
▶
When traveling on public road or attaching/detaching rear implement, set auto-
leveling control to
Manual
mode.
▶
If 3-point linkage is modified or changed arbitrary, the auto-leveling control can be
operated normally. Do not modify or change the length or connection points of the
3-point linkage
Caution
Manual up/down switch
is only for Manual mode(M), use this switch when changing the slope of
the implement arbitrary. If pressing and holding the switch to UP position, leveling cylinder of the
rear 3-point hitch shall lift the right side of the implement.
Slope setting dial
is only for Automatic (A) or Slope (S) mode. If turning this dial to (+) or (-) from
“O” position, the implement shall be tilted to corresponding position and auto-leveling controller shall
recognize this plane as horizon.
If it is necessary to modify or change the tilt of the implement, adjust it with this dial.
Sensitivity switch
has three modes, “Sensitive”, “Normal” and “Insensitive”.
- Sensitive : approximately 0.6
°
dead-band.
- Normal : approximately 1.2
°
dead-band.
- Insensitive : approximately 2.4
°
dead-band.
Depending on the ground condition, the implement controlled by auto-leveling control can be shaken
by itself in Sensitive mode. At this time, adjust this switch to Normal or Insensitive mode.
When lifting rear implement with one touch up/down switch or position control lever in Automatic(A)
or Slope(S) mode, the implement shall be set automatically parallel with the tilt of the tractor in lifted
position. When lowering the implement, the tilt of the implement shall be returned originally.
Leveling
mode switch
Up
Down
Slope
setting dial
Manual
up/down
switch
Sensitivity switch
⑩
Auto-Leveling Control (EHL,
optional)
Auto-Leveling Control is a automatic control
device which keep the tilt of the rear implement
horizontal electro-hydraulically when the tractor
is tilted by uneven ground.
When turning the key switch ON,
Leveling
mode switch
shall be set for Manual model(M).
For Automatic (A) mode or Slope (S) mode,
press the “MODE “button. If pressing this button
repeatedly, the mode shall be changed orderly
with LED light.
-
Manual mode (M)
: The tilt of the rear
implement does not controlled automatically.
-
Automatic mode (A)
: It is useful when
working on a even ground.
-
Slope mode (S)
: It is useful when working on
a slope ground.