LS tractor MT5 Series, Руководство оператора, Страница: 157 / 192

5 - 22
5-9. Every 500 hour check
(1) Changing Front axle oil
① Center housing
 Stop the tractor on a level surface and apply
parking brake.
 Clean air-breather and the surrounding area.
 Set a container under the drain plug.
 Remove oil filling inlet plug first, and drain plug.
 Drain oil completely, and clean with care and
tighten the drain plug.
 Add new oil into the oil filling inlet with checking
if the oil flows out through the oil check port.
 Clean with care and tighten the oil check port
plug.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil drain position
②
Final gear cases
 Stop the tractor on a level surface and apply
parking brake.
 Set a container under the oil plug of the final
gear case.

Before draining oil, rotate the wheel end so that
the oil plug is at the highest position.
 Partially unscrew the oil plug to release possible
pressure.
 Place the oil plug downward and remove the oil
plug. Drain oil completely.
 Add new oil into the oil filling inlet with checking if
the oil flows out through the oil check port.
 If necessary, wrap the sealing tape on the oil
plug, and tighten the oil plug.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Oil filling inlet & check position
Oil plug
▶ Before draining oil, partially unscrew the oil plug to release possible pressure at the
highest position of the oil plug.
Caution
Oil filling inlet & check port
Drain plug
Air-breather