LS Industrial Systems Metasol Series, Технический каталог, Страница: 72 / 156

71
F
A visual inspection - inside and out - should be performed immediately upon receipt of the ACB and before
removing it from the truck. Shipping papers should be checked to ensure all boxes or other accompanying
pieces have been received. If any damage or shortages are evident, a claim should be filed at once with
the carrier, and the nearest LSIS sales office. Claims for shortages or other errors must be made in writing
to LSIS within 30days after receipt of ACB. Failure to do so constitutes unqualified acceptance and a
waiver of all such claims by the purchaser.
Receiving
Removable lifting plates are provided on the top of the Susol ACB structure for insertion of hooks to lift the
complete structure. This is the only recommended method of moving the Susol ACB structure. Extreme
care should be used not to damage or deform the unit if other moving methods are employed.
Handling
If it is necessary to store the equipment before installation, keep it in a clean, dry location with ample air
circulation and heat to prevent condensation. Like all electrical apparatus, these units contain insulation
that must be protected against dirt and moisture. Outdoor units may be stored outside only if roof caps are
installed, space heaters energized and any openings are enclosed.
Storage
1. Do not pass cables or ropes through support holes.
2. Always use load rated shackles or safety hooks in support holes.
3. Rig so that legs of sling are no less than 45 degrees from horizontal.
Lifting Instructions
A crane or hoist can also be used to handle the breaker, if the lifting device is not available. If a forklift is
utilized, the following precautions should be taken when moving circuit breakers:
1. Keep the breaker in an upright position only.
2. Make sure the load is properly balanced on the forks.
3. Place protective material between the breaker and the forklift to prevent bending or scratching.
4. Securely strap the breaker to the forklift to prevent shifting or tipping.
5. Excessive speeds and sudden starts, stops, and turns must be avoided when handling the breaker.
6. Lift the breaker only high enough to clear obstructions on the floor.
7. Take care to avoid collisions with structures, other equipment, or personnel when moving the breaker.
8. Never lift a breaker above an area where personnel is.
Moving
Warning
Installation and Service Condition
1. Safety Precaution