Louet Octado, Инструкция по эксплуатации

Страница: 30 / 42

28
Take the treadle and turn the screw eye in
the hole at the end until the threaded part
is completely into the wood. The picture
shows how the eye needs to be located
relative to the treadle.
The 2 screw eyes should be screwed into
the little holes at the bottom of the dobby
treadle.
The hole left in the bar is from the old
system and is not used/drilled anymore.
Place a small washer and then the 22 mm
spacer bushing onto the lag bolt. Put the
bolt through the hole at the other end of
the treadle and slide the large washer
around the lag bolt. Watch out that the
head of the lag bolt sits on the same side
as the screw you just installed.
Tighten the lag bolt to the front of the left
upright. Again, you choose the hole
depending on the position the foot rail has
been mounted. You can let the other end
of the treadle rest on the lower buffer.
Take the cord guide block with one pulley,
and take the pulley off.
Attach the guide block with the two 4 x 35
mm screws to the inside of the upright.
Insure that the shaft is angled towards the
loom.
Slide the pulley and cap back onto the
shaft.