23
Now we will check if the beater is even and make a correction if necessary. Take the beater by its
handle and pull it towards you, one or two inches. If the beater is even, both uprights will leave the
buffers at the same moment and also tough the buffers at the same time when you let the beater go
back and rest against them. If this is not the case, the beater is not even and you will correct that
with the small cardboard strips from the hardware bag.
The upright that leaves the buffer latest
when you pull the beater, is the one that
needs one or more cardboard strips in its
slit connection with the lower reed holder.
Unscrew the m6 bolt several turns, so that
some play is created in this connection.
Slide a cardboard strip completely into the
slit at the bottom and fasten the m6 bolt
again.
Check if the beater is even now, and if not,
use one or two more strips in the slit.
Hook the end of the tie-up cords around
the screw heads of both, cloth beam and
warp beam. Hardware bag 6 is the same
for Octado 70 (28”) Octado 90 (36”) and
Octado 110 (44”). So with the Octado 70
and 90, you will have extra tie-up cords,
which will not be used.
Содержание Octado
Страница 2: ......
