Lonking LG833NG, Руководство пользователя

Страница: 83 / 134

83
so as to lower the boom to the position whereby the lower linkage point of the boom is
~50cm above the ground.
Handling of materials

Under any of the following circumstances, the self-handling may be carried out:
①
The road is soft, the place is not flattened, and it is impossible to use freight
vehicle.
②
The handling distance is no more than 500 meters, and the use of freight vehicle
is not economical.

In the course of handling, remain the lower linkage point of the boom at the
articulating position (about 50cm above the ground), and turn backwards the bucket
to the limit position (the stopper on the bucket contacts with the boom), so as to
ensure that the handling operation may be carried out safely and smoothly and no
material will fall out.

The speed of the loader in the course of handling operation depends on the handling
distance and road conditions. When passing any depression or crowing portion, just
release the accelerator pedal, and, if necessary, intermittently apply the service brake,
so as to slow down the loader, make the loader pass the obstacle slowly, reduce the
impact to the loader and prevent the materials from falling down.
WARNING: Do not lift up the bucket to a relatively high position for carrying out
the handling operation, otherwise the loader may overturn.
Unloading of materials
1
Discharging of materials into truck or hopper

When the loader which is loaded with materials is 15 meters away from the truck or
hopper, just release the accelerator pedal, and if necessary, intermittently apply the
service brake, so as to slow down the loader and make the loader approach the truck
or hopper at a low speed. At the same time, pull the working device joystick
backwards to the limit position until it is caught up by electromagnet. Then release the
joystick and it will not return to the middle position automatically. The boom will be
raised continuously until it reaches the limit height, and then the electromagnet will be
powered off. The joystick will automatically return to the middle position, and the
boom will stop to rise. In this course, the driver shall carefully drive the loader,
carefully observe the approach by the bucket to the truck or hopper, and may not
make the bucket collide with the truck or hopper.

When the bucket is above the truck or hopper, just step down the brake pedal so as to
stop the loader, push rightwards the joystick so as to tilt forwards the bucket, and then
dump the materials into the truck or hopper. At this time, be sure to carefully observe
the movement of the bucket, and be sure not to make the bucket collide with the truck
or hopper. If the material is very sticky, just push the joystick forwards and backwards
so as to make the stop block of the bucket collide with the boom and make the