33
1.6PRECAUTION FOR OPERATION
Do not get close to the edge of a cliff.
When the machine shoves the soil descending a cliff or onto the peak of the slope, the
load will suddenly become lighter. In such case, due to a sudden increase in walking
speed, it is dangerous; therefore, it is important to reduce the speed.
When the bucket is full, do not give the machine a sudden start, turn or stop.
When loading unstable objects, such as round or
cylindrical objects, layered plates, if the working
device lifts, the loading objects may fall down to
the top of the cab, and cause serious injuries or
damages. Therefore, note that do not lift the
working device too high or heavy tilt bucket
backward.
If the working device suddenly dropped or stopped, its reaction force may cause the
machine overturning. Be careful to operating the working device, especially when it is
loaded.
For a good visibility, please pay attention to the following tips:
When operating in a dark place, turn on the switch of working lamp and headlamp; if
necessary, install illumination equipment on site.
Do not operate the machine in fogy, obscure, snowy or heavy rainy days or other poor
visibility conditions until there is sufficient visibility for operation.
For collision prevention of working device with other objects, please pay attention to the
following tips:
When operating in tunnel, under the bridge, wire or other height limitation places, pay
caution not to let the bucket hit anything.
When use dump truck to load, check whether there is anybody around the dump truck,
pay caution not to let the bucket of dump truck hit driver’s cab. In order to prevent
collision with other objects, and cause accidents, the machine shall operate at safety
working speed, especially in limited spaces indoor and other areas with many
vehicles.
1.6.1 METHODS OF USING A BRAKE
Do not put your feet on the brake pedal unless it is necessary.
Do not frequently step the brake pedal unless it is necessary.
When walking down hill, take the engine as a brake, never use gear shifting or place the
gearbox in neutral position.
Содержание LG833NG
Страница 56: ...56 2 2 OUTLINE DRAWING OF LG833NG LG833BGIII 00I WHEEL LOADER...
Страница 64: ...64 Rear combination lamp Rear working lamp In cab lamp...
Страница 133: ...133...