Lonking LG833NG, Руководство пользователя

Страница: 60 / 134

60
energized.
4.
START
--Insert the starter switch key and
clockwise turn it to the second position
“START”. With the key at “START” position,
the motor is energized to start the engine.
Immediately release the key after the engine
has been started, the key will automatically
return to “ON” position.
Before starting the engine, check that the negative-pole switch of the battery is
turned to “ON” position, and the gearshift handle is at the “Neutral” position.
If the engine cannot be started successfully, turn the starter switch to “OFF”
position, and then start the engine again, and do not just turn the starter switch to
“ON” position and then start the engine again. Failure to do so will cause damage
to the starter switch! Each time of starting shall not take more than 15 seconds;
interval between two times of starting shall be at least 30 seconds; do not
continuously start the engine for more than 3 times; if it is necessary to start the
engine for more than 3 times, wait until the motor cools down. Failure to do so will
shorten the service life of battery and cause damage to the motor.
3.4SERVICE BRAKE PEDAL
The service brake pedal (foot brake) is arranged
on the left front floor of cab. The service brake
system of loader is single pedal single-line
system. To apply brake to front and rear axles,
tread the service brake pedal. In this case, the
brake lamp will light up.
To release service brake, take your foot off the
pedal.
Warning
Warning