Lonking LG833NG, Руководство пользователя

Страница: 81 / 134

81
also discharge all water in the evaporator of A/C system.
10) Fix the front/rear frames with the frame fixing rod.
2. During Storage
1) Start up the engine once a month, run each system, and apply lubricating oil/grease to
all moving pins/shafts and the propeller shaft so as to get all moving parts well
lubricated. In addition, charge the battery.
2) Before starting up the loader, wipe away the grease on the hydraulic oil cylinder piston
rod.
3) Apply antirust agent to all portions which may get rusted.
NOTE: If the antirust agent is used indoors, be sure to open doors and windows, so
as to get the place well ventilated and discharge the toxic gas.
3. After Storage
When the loader is to be used after long-term storage, be sure to carry out the following
operations:
 If the lubricating oil of engine, gearbox and drive axle as well as the hydraulic oil and
anti-freezing fluid are not replaced before storage, replace them after storage.
 Apply greases to all moving pins/shafts and the propeller shaft.

Before starting up the engine, wipe away the grease from the hydraulic oil cylinder
piston rod.
4.4WORKING OF LOADER
4.4.1 PREPARATION BEFORE WORKING
 Before the commencement of the working, use the loader to flatten the working place,
remove crowing portions, fill depressions, and remove the ground surface which is wet
and slippery. Clear away all large and sharp stones on the working place, so as to
prevent the tires from being scratched.
1.
If using the loader to load materials onto or unload materials from a truck or hopper,
adjust the limit height of the caging device of the boom on the basis of the height of
the truck or hopper, so as to ensure that the bucket may safely enter into and exit
from the truck or hopper and to avoid the impact on truck or hopper imposed by
materials discharged from an excessively high position.
4.4.2 GENERAL SKILL
Common shovel-loading method