Operating instructions
ScanAfia X TK, S, ICU Version 1.5
Copyright © Lojer Oy, 2015
28
7
Installing and operating accessories
This section gives instructions on how to install and operate the accessories of
the hospital bed. Accessories are ordered separately.
IMPORTANT!
Always use exclusively accessories approved by the
manufacturer!
IMPORTANT!
We recommend that you disconnect all protruding accessories
of the bed to minimize the risk of collision.
IMPORTANT!
These instructions define the installation and removal
procedures for specific accessories. These installation and
removal procedures are intended to be performed by the
operator. Other accessories are to be installed by service
personnel authorized by Lojer.
7.1 Ends (70356KP - 70361KP)
The hospital bed has one painted or chromium plated head of the bed as
standard equipment. The ends of the bed available as accessories aim to
prevent the patient from falling and to improve patient safety when the rails are
used. The head of the bed is not normally attached to the bed (thumbscrews for
the head end are available separately). The head end is removed by lifting the
end upward. The foot end is fastened with thumbscrews.
Figure 59.
End 80cm 70356KP
Removing the foot end. Turn the thumbscrews at the lower edge of the end anti-
clockwise approximately one cycle and lift out the end.
Fastening the foot end. Make sure that the thumbscrews at the lower edge of
the end have been opened at least one cycle. Put the end back in place and
tighten the thumbscrews with fingers (Figure 59).
Thumbscrews
