LOGICLINK - MANUAL // PAGE 24
8 OPERATION (MANUAL)
CAUTION
Risk of minor or moderate injury through uncontrolled movement
The table may not always stop exactly at the expected position. Failure to anticipate the
table's movements may lead to minor or moderate injury through crushing.
• Wait until the system has completely stopped before attempting to use the table
CAUTION
Risk of minor or moderate injury through unsecured objects
While the table moves up and down, unsecured objects may fall off the table and onto
body parts. This may lead to minor or moderate injury through crushing.
• Ensure loose objects are kept away from the edge of the table
• Do not leave unnecessary objects on the table during movement
This section of the Operating Manual contains a selection of instructions for operating the Table System to
which the LOGIClink is connected using the buttons on the LOGIClink's housing.
LOGIClink is compatible with a large number of LOGICDATA Control Boxes and the DYNAMIC MOTION
system:
• Before using a Control Box-connected Table System, you must also read the Operating Manual
for the installed Control Box, including all relevant safety information, in full.
• Before using a DYNAMIC MOTION system-connected Table System, you must also read the
DYNAMIC MOTION system Manual, including all relevant safety information, in full.
• If you have connected another Handset to the LOGIClink using the Retrofit Cable, consult the
Manual of your chosen Handset for operating instructions.
8.1 ADJUSTING THE TABLE TOP HEIGHT
CAUTION
Risk of minor or moderate injury through crushing
Your fingers may be crushed when you attempt to change the height of the table
• Keep fingers away from moving parts
• Ensure that no persons or objects are in the table's range of motion
INFO
The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
fined stopping point has been reached
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached
