LOGICLINK - MANUAL // PAGE 22
7.5 CONNECTION: DYNAMIC MOTION SYSTEM
OPTION
7.5.1 REQUIRED COMPONENTS
1
LOGIClink
2
DYNAMIC MOTION system-compatible Power Hub (e.g. DMP240)
3
Micro-USB Cable (Optional - Supplied by Reseller)
4
LOGIClink-DM system Cable (
DMC-LL-y-1800
)
INFO
The
DMC-LL-y-1800
Cable has 2 connectors:
• 4-pin Mini-Fit (plugs into the Power Hub)
• 10-pin Mini-Fit (plugs into the LOGIClink)
INFO
The Micro-USB Cable is used to connect LOGIClink to your PC or Mac. When connected
to the DYNAMIC MOTION system, it can also be used as a parameterization tool. It is
not required during standard operation of the table system. For further advice on soft-
ware options, contact LOGICDATA.
7.5.2 CONNECTING THE LOGICLINK
CAUTION
Risk of minor or moderate injury through electric shocks
Connecting Cables while the DYNAMIC MOTION system is connected to the Power Unit
may lead to minor or moderate injury through electric shocks.
• Do not connect the DYNAMIC MOTION system to the Power Unit before the
LOGIClink has been safely connected.
1. Insert the
DMC-LL-y-1800
Cable into the LOGIClink using the 10-pin Mini-Fit connector.
2. Lay the Cable along the underside of the table top, making sure it is secured.
3. Connect the 4-Pin Mini-Fit connector to the Power Hub.
4. (Optional) connect the LOGIClink to your PC or Mac using the Micro-USB cable.
5. Connect the DYNAMIC MOTION system to the mains. Consult the DYNAMIC MOTION system
Manual for assembly and safety advice.
7.5.3 NEXT STEPS
After the LOGIClink is connected to the DYNAMIC MOTION system, assembly differs depending on the ver-
sion of the LOGIClink you have installed.
LOGIClink Corporate and Personal Standard: Go to Chapter 7.6, Marking the NFC Reading Area.
All other variants: Assembly is now complete. Go to Chapter 8, Operation.
