DMD660 - OPERATING MANUAL // PAGE 22
9.2 STEP 2 - ATTACHING THE SPINDLE END
The Spindle End is connected to the Height-Adjustable Column with a specially-made Bottom Plate.
NOTICE
Attaching the Spindle End incorrectly could damage the DMD660 irreparably. The following
guidelines apply during this stage of the assembly process. Failure to comply will void war-
ranty claims.
• Do not lift the DMD660 by its cable
• Ensure the Bottom Plate is designed according to LOGICDATA specifications
• Use a Torque Screwdriver to tighten the Screw to the recommended torque of 2.5 - 3 Nm.
9.2.1 REQUIRED COMPONENTS
1
DMD660
2
Spindle Attachment Point (see below)
3
Bottom Plate and Mounting Screw (developed by
Reseller: contact LOGICDATA for specifications)
Tool
Torque Screwdriver
INFO
LOGICDATA provides specifications for the Bottom Plate only on request. These in-
clude dimensions and tolerances, as well as notes on material selection and assembly.
Failure to adhere to LOGICDATA specifications will void warranty claims.
The Spindle Attachment Point has an M4 thread. This fixes the Actuator to the Bottom Plate of the Height-
Adjustable Column using the Mounting Screw (Fig. 11).
Fig. 11: Spindle Attachment Point
9.2.2 PROCESS
To attach the Spindle End of the DMD660:
1. Insert the Mounting Screw through the Bottom Plate into the Spindle Attachment Point
2. Use a Torque Screwdriver to tighten the Screw
9.2.3 COMPLETING ASSEMBLY
After the DMD660 is attached to the Height-Adjustable Column, you must connect the Actuator Cable to
the System. Refer to the DYNAMIC MOTION System Manual for instructions on your chosen configuration.
M4
10
12
3
2
1
