ACS-CB-SENS - MANUAL // PAGE 12
6 ASSEMBLY
This chapter describes the process of installing the ACS-CB-SENS processing unit and the LOG-PRT-DMS
Collision Sensor into the Height-Adjustable Table System.
6.1 SAFETY DURING ASSEMBLY
WARNING Risk of death or serious injury through electric shocks
Collision Sensors and their components are electrical devices. Basic safety precautions
must be taken at all times. Failure to observe electrical safety precautions may lead to
death or serious injury through electric shocks.
• Ensure that the Collision Sensor is not connected to the Control Box during assembly
• Do not convert or modify the Collision Sensor in any way
• Check the Collision Sensor and its Cables for visible damage. Do not install or op-
erate damaged products.
CAUTION
Risk of minor or moderate injury through improper handling
Improper handling of the product during assembly may lead to minor or moderate in-
jury through cutting, pinching, and crushing.
• Avoid contact with sharp edges
• Be careful while handling tools that may cause personal injury
• Ensure assembly complies with the generally accepted standards and guidelines of
electrical engineering and furniture manufacturing
• Read all instructions and safety advice carefully
CAUTION
Risk of minor or moderate injury through tripping
During assembly and operation, poorly routed Cables may become a trip hazard.
Tripping over Cables may lead to minor or moderate injury.
• Ensure that Cables are routed properly to avoid trip hazards
• Be careful not to trip over Cables when installing the Collision Sensor
NOTICE
Ensure proper ESD handling during assembly. Damage that can be attributed to electro-
static discharge will void warranty claims.
NOTICE
To avoid damage to the product, measure the dimensions of the Collision Sensor before
assembly.
NOTICE
Before assembly, all parts must be acclimatised to the ambient conditions.
NOTICE
Do not lift the Collision Sensor by its cable. This will cause irreparable damage to the
product.
INFO
Perform a product risk assessment so that you can respond to potential residual haz-
ards. Assembly instructions must be included in your end user Operating Manual.
6.2 REQUIRED COMPONENTS
1
ACS-CB-SENS Processing Unit
1
LOG-PRT-DMS Collision Sensor
4
Mounting Screws (developed by Reseller: contact LOGICDATA for specifications)
Tool
Torque Screwdriver
Tool
Drill or Drilling Machine
