ACS-CB-SENS - MANUAL // PAGE 6
2 SAFETY
2.1 TARGET AUDIENCE
This Operating Manual is intended for Skilled Persons only. Refer to
Chapter 2.8 Skilled Persons on page 9 to
ensure that personnel meet all requirements.
2.2 GENERAL SAFETY REGULATIONS
In general, the following safety regulations and obligations apply when handling the product:
• Do not operate the product unless it is in a clean and perfect condition
• Do not remove, change, bridge, or bypass any protection, safety, or monitoring equipment
• Do not convert or modify any components without written approval from LOGICDATA
• In the event of malfunction or damage, faulty components must be replaced immediately
• Unauthorized repairs are prohibited
• Do not attempt to replace hardware unless the product is in a de-energized state
• Only Skilled Persons are allowed to work with ACS-CB-SENS Collision Sensors
• Ensure that national worker protection conditions and national safety and accident prevention
regulations are observed during operation of the system
2.3 INTENDED USE
The ACS-CB-SENS is a Collision Sensor Unit for electrically Height-Adjustable Tables. It is installed by
Resellers into Height-Adjustable Table systems. It is used to recognize collisions between the Table System
and other objects. It is intended for indoor use only. It may only be installed in compatible Height-Adjustable
Table Systems and with LOGICDATA-approved accessories. Contact LOGICDATA for further details. Use be-
yond or outside the intended use will void the product’s warranty.
2.4 REASONABLY FORESEEABLE MISUSE
Usage outside of the intended use may lead to minor injury, serious injury, or even death. Reasonably fore-
seeable misuse of the Collision Sensor includes, but does not extend to:
• Connecting unauthorized parts to the product. If you are unsure as to whether a part can be used
with a Collision Sensor, contact LOGICDATA for further information
DANGER
The RJ sockets on the ACS-CB-SENS may only be used to accommodate LOGICDATA-
approved sensor units. Inserting other telecommunication-type sensors into these
terminals may cause damage to the Control Box or other products in the system.
For telecommunication type connectors not used for connection to the telecommuni-
cation network should be provided with a marking identifying the specific function or
circuit characteristic the connector or terminal is used for.
