LOFTNESS Battle Ax 207460, Руководство пользователя и каталог запасных частей, Страница: 28 / 66

24 Battle Ax Skid Loader OM
Maintenance
Tooth Removal and Installation
Quadco Teeth
2 1
3
Remove the bolt and washer (1 and 2) and tooth (3).
Use copper based anti-seize when reinstalling the bolts.
Torque to 240 ft.-lbs.
IMPORTANT : When a damaged tooth is replaced, the
tooth directly opposite (180 degrees)
must be replaced at the same time to
retain balance.
Sprocket Removal (Cont’d)
2
1
3
4
1
2. Remove the two screws (1) from the taper lock
bushing (2) of the sprocket (3).
3. Insert one of the screws into the threaded hole (4).
4. Tighten the screw until bushing grip is released. (If
excessively tight, lightly hammer face of sprocket
using drift pin or sleeve).
NOTE: Never hit sprocket directly with hammer.
5. Replace the sprocket by cleaning the shaft, bore of
bushing, outside of bushing and hub bore of all oil,
paint and dirt. File away any burrs.
6. Insert bushing into hub. Match the hole pattern, not
threaded holes (each complete hole will be threaded
on one side only).
7. Apply a thread-locking compound to screws and
thread into the two opposing holes.
8. Position assembly on shaft and alternately torque
screws to 35 ft.-lbs.
9. To increase gripping force, hammer face of bushing
using drift or sleeve.
NOTE:
Do not hit bushing directly with hammer.
10. Re-torque screws after hammering.
11. Recheck screw torque after initial run-in, and
periodically thereafter, repeat steps 4, 5 & 6 if loose.
12. Check alignment of the sprocket. Repeat sprocket
removal and assembly procedures if necessary.