Other settings
If required, you can configure additional parameters in the Settings menu of the
Sound Projector
. These settings are only intended for trained technical personnel.
➠
Unless you have sufficient expertise, do not make any changes to the settings
in this area, as this may maladjust the unit to an extent that it no longer
works properly afterwards.
Loudspeakers
You can determine the number of sound beam output channels and the audio
output mode.
Select
AV station preset
of the TV-set to which the
Sound
Projector
is connected.
Set the remote control for
Sound Projector
operation. The
Sound Projector
switches on automatically.
Press the
MENU
briefly. The menu
Settings
appears.
Select the option
Loudspeakers
.
Confirm
OK
2x.
¼
·
·
·
·
·
·
·
[
] / [
] :
Up / Down
[OK] :
Enter
SET MENU
MEMORY
AUTO SETUP
MANUAL SETUP
SOUNDSET MENU
SOUNDOUT MENU
INPUT MENU
DISPLAY MENU
Number of channels
Set
5.1 ch
or
7.1 ch
mode
Beam
mode
Depending on your setting for
Number of channels
,
you can choose to set
5.1 ch
: 3 Beam or 3 Beam or 5 Beam, or
7.1 ch
: 3 Beam, 3 Beam plus 2
or 5 Beam plus 2 (also see Listening mode on
page 24)
Connections
You can make basic settings for the inputs/outputs.
Assign connections
You can assign analogue and digital wired (coaxial) and optical inputs respectively
to the video inputs (page 23).
Renaming the connections
You can rename the connections, e.g. so that it can be seen from the display of
the
Sound Projector
, which connected units (e.g. Blu-ray-Player) are set upon
selecting the signal source (page 23).
Setting HDMI
Here, you can make additional settings for the HDMI-interfaces.
Support
Audio
Select
Loewe SP
to play back HDMI audio signals
on that unit. Select
Other
, to play back HDMI audio
signals on one of the components connected to the
HDMI OUT
socket
Audio
select
Here, you can set whether the audio channel of the
HDMI-IN
-sockets
1-4
should be active
HDMI
control
Set this option to
On
if your TV-set and the connected
sets (e.g. Blu-ray-Player) support the HDMI CEC
function. There is then an automatic switch-
over to the respective HDMI source. For a device
configuration as described on pages 13-14, set this
option to
Off
Display
You can make settings for the device display of the
Sound Projector
.
F.DISPLAYSETUP
You can set the brightness of the display here
OSD
setup
You can adjust the colour and position of the menu
Settings
here.
Language
setup
You can set the language of the operating interface
here (see page 21)
Unit
setup
You can set the unit of measure to feet or metres
- 30
