Start-up
➠
During auto set-up, the listening room should be free of noise interference.
Please leave the room during this time so that the sound beams can spread
without disturbance.
➠
If an error occurs during auto set-up, a warning will sound and a message
will appear on the TV screen (page 32). If necessary, check the conditions
described above for the
Sound Projector
to work perfectly.
➠
Auto set-up takes about 3 minutes and a chime sounds when it finishes.
➠
You can save three listening positions and call them up again, e.g., to take
changing conditions in the listening room into consideration.
➠
Position the microphone at least 1.8 m away from the
Sound Projector
centred on it on a level surface.
After auto set-up has been completed, a message will appear
on the screen.
Example 1 - Successful auto set-up:
OK
SOUND COMPONENTS WIZARD
Room tuning has been completed successfully.
With the
key the position and the corresponding adjustments of the auto
setup are stored to "Position 1 (MEM1)".
SOUND PROJECTOR
Store settings
Proceed
OK
OK
Example 2 - Failed auto set-up:
OK
SOUND COMPONENTS WIZARD
Hint: The auto setup failed.
Make sure that your listening room is as quiet as possible.
Please restart the auto setup with the
key.
SOUND PROJECTOR
Start auto setup
Proceed
OK
OK
➠
If the message “Note: The auto set-up failed due to problem E-1 (room is too
noisy)“ is displayed, please repeat the auto set-up process. Please also read
the “Error messages for auto set-up“ on page 32.
OK
Apply results of auto set-up.
OK
SOUND PROJECTOR
Rotate TV
-30
Proceed
OK
If the Loewe TV set is equipped with swivel castor control, use
to turn the TV to the required listening position.
Close the menu.
Remove the microphone now from the
Sound Projector
.
The
Sound Projector
is now ready.
You will find information on operating the
Sound Projector
from page 23 onwards.
- 20
