LOBENN LB200186, Руководство по установке, Страница: 57 / 86

Note : Use These Instructions for Standard Installations
Removing and Replacing the Terminal Strip
Cover
To avoid damaging the tamper switch,
which opens and closes the tamper
circuit of the LNI 2000, the terminal
strip cover must be removed and
replaced with care. Please read these
instructions carefully.
Removing the Cover
1. Unscrew the screw holding down the cranberry terminal strip cover. This
screw is located at the rear of the terminal strip cover.

Metal case: remove screw and set it aside.

Plastic case: screw is not removable, loosen only.
1. Lift the screw end of the terminal strip cover slightly, lifting straight up.
2. Pull the terminal strip cover straight back to free it from the slot at the front
of the LNI 2000.
3. When it is free, lift it off the
body of the LNI 2000, revealing
the terminal strips.
4. Notice that the terminal strip
cover is shaped to depress and
close the tamper switch when it
is in place. Use extreme caution
when replacing the terminal
cover.
5. Thread a tie wrap through the
tie wrap anchor just inside of
the knockout. This will be used
to secure wires running through
the knockout.
LNI 2000 Installation Manual
CAUTION
The terminal strip cover
must be raised and
lowered vertically (straight
up or down) to avoid
bending or breaking the tamper switch. If
the tamper switch breaks, it cannot be
fixed or replaced in the field. The entire
LNI 2000 unit must be replaced.
57