LOBENN LB200186, Руководство по установке, Страница: 11 / 86

Note : Use These Instructions for ULC Installations

Conduit between enclosure housing the LNI 2000 and router with
appropriate Ethernet cabling in place, may be same conduit as above.

Active POTS telephone line from alarm panel (optional, for
redundancy).

The LNI must be powered by a ULC listed burglary alarm panel or a
ULC listed UPS (Uninterruptible Power Supply).

If LNI is connected to products or components of products, which
perform communications functions only, these products or components
shall comply with the applicable requirements specified in CAN/CSA-
C22.2 No. 60950-1, Information Technology Equipment - Safety - Part
1: General Requirements. Such products include, but are not limited to:
A) hubs,
B) routers,
C) network interface devices,
D) third party communications service providers,
E) digital subscriber line (DSL) modems, and
F) cable modems.
Specifications
The table below lists the specifications for the 10-Mbps 10BaseT cable.
Parameter RJ-45
Cable specification Category 3 or Category 5 UTP with 22 to 24 AWG
Maximum segment length 100 m (328 ft.) for 10BaseT
Installation Options
There are several possible installation options.
These options range from a UL listed enclosure containing the alarm panel, LNI
2000, UPS, a 12V regulator such as the GE 24DC12 and router mounted on a
ULC listed mounting plate (for example, for a new installation) to each
component requiring on-site assembly (for example, for installation in an
existing building with an existing fire alarm system.)
LNI 2000 Installation Manual
11