LOBENN LB200186, Руководство по установке

Страница: 55 / 86

Note : Use These Instructions for Standard Installations
Step Six: Test The System
Verify that all LEDs are lit, indicating successful configuration and
communication between LNI 2000 and LNS 2000 at the Fire Signal Central
Station. The Power LED should be blinking on a one second OFF, three seconds
ON cycle, while the IP Link and the IP Monitoring LED's should be on.
Note : If all the Power and IP Link LEDs begin flashing, there is a
firmware update in progress. This flashing may continue for several
minutes. The IP Monitoring LED flashes only during an alarm
transmission.
Testing the Internet Connection
1. Check that the “IP Link” and “IP Monitoring” LEDs are lit. These LEDs
light when Step Four: Connect to Internet is completed.
2. Send at least one (1) test alarm from the alarm system keypad. See the
panel operating manual for more information on how to send a test alarm.
3. Verify that the IP Monitoring LED is flashing and that the test alarm is
correctly received at the central station
Communication Trouble Alarm Test One
1. Disconnect the LNI 2000 Internet connection by unplugging the RJ45
jack from the “Internet” port. The IP Link LED will flash.
2. After the programmed communication trouble alarm time has elapsed, the
IP Monitoring LED will go out and the central station will receive a
communication trouble alarm.
3. If backup phone line is in place on second dialer send at least one (1) test
alarm from the alarm system keypad. See the panel operating manual for
more information on how to send a test alarm.
4. Verify that the test alarm (if applicable) and the “Communication Trouble
Alarm” are received correctly at the central station.
5. Reconnect Internet cable removed in Step 1.
6. Check that IP Link and IP Monitoring LED are lit to verify that the alarm
system has restored communication with the central station. These LEDs
should re-light within seconds.
LNI 2000 Installation Manual
55