LOBENN LB200186, Руководство по установке, Страница: 17 / 86

Note : Use These Instructions for ULC Installations
5. Configure the LNI 2000 by entering the values specified by the work order
into the appropriate boxes on the
LoBenn LNI Configuration screen. Save
the settings by clicking “Submit.” See pages 35-37 for more information.
Note : To be ULC CAN/ULC-S559-04 compatible, the
communication trouble alarm time programmed during this step must
not exceed the
maximum of 90 seconds. LoBenn recommends a
setting of 90 seconds.
Note: To be ULC CAN/ULC-S559-04 compatible, the Tamper
Switch Enable must be set to use the Tip/Ring method. This is
applicable for panels/dialers such as the GE Fireshield series which
have the following characteristics:
•
There is no dedicated tamper circuit between the panel/dialer and
the LNI
•
The Tip/Ring wires are shorted to the T1/R1 leads respectively
when the dialer is on hook.
6. To change the LNI 2000 password, click on Change Password on the upper
right hand corner of the LoBenn LNI Configuration
screen.
Note : For security reasons, LoBenn Inc. recommends changing the
password after the LNI has been configured.
7. The Change LNI Login Password screen will display. Type your new pass-
word into the appropriate box. Retype the password to confirm it. Click
Submit to submit the new password.
Note: This new password should be specified on the work order. If
the new password is not specified on the work order it should be
reported to the appropriate personnel. LoBenn Inc. is not responsible
for any loss, damage or inconvenience resulting from misplacing,
mis-communicating or otherwise not recording this password.
LNI 2000 Installation Manual
17