LNC LNC-T800, Руководство оператора

Страница: 98 / 100

LNC-T800
LNC Controller Operation Instruction
94
LNC Technology Co., Ltd.
2.10 Setting of Work Coordinate System (00, G54~G59)
The method to set work coordinate system is as the following
：
1. Make sure machine preparation is done.
2. Switch to <OFFSET> module.
3. Click
【
WORK
】
function button to switch to coordinate system setting screen.
4. Use Up, Down, Right, Let buttons to move cursor to the work coordinate system to be set.
5. There are 2 methods to set coordinate system including manual input and button input. According to
necessity to select from the following methods.
‹ Manual Input
：
a. In input line, directly input desired coordinates of each axis. The format of input is X_Y_Z_, e.g.
X10.Y20.Z30.
b. Remember to input the points to avoid misconception. E.g. X100. Z200.
c. Click <INPUT> to input values into controller, and coordinate system setting is done.
‹ Button Clicking Input
：
a. Introduction of function buttons
：
【
SET All
】：
Set current coordinate values of all 3 axes of the machine directly into the
coordinate system where cursor stays.
【
SET X
】：
Set current coordinate values of X of the machine directly into the coordinate
system where cursor stays.
【
SET Y
】：
Set current coordinate values of Y of the machine directly into the coordinate
system where cursor stays.
【
SET Z
】 ：
Set current coordinate values of Z of the machine directly into the coordinate system
where cursor stays.
b. Move machine coordinate to desired teach-in position at first.
c. According to the axis direction needed to teach in to click corresponding function buttons. E.g. To
teach in X-AXIS, click
【
SET X
】；
to teach in coordinates of all axes, click
【
SET All
】
.